Shop P275/40R17 tires in stock with confirmed size specs, validated diameter in inches, approved rim width range, and verified vehicle fitment before purchase.
Browse and filter P275/40R17 tires from Yokohama, Toyo, Nitto and more to quickly find your ideal fit.
P275/40R17 tires have 275 mm in section width, use a 40% aspect ratio, and fit 17-inch wheels. The calculated diameter is approximately 25.7 inches (mainstream UHP products spec at 25.63 - 25.67 inches with drag-radial constructions reaching up to 25.8 inches).
The P275/40R17 size appears on performance coupes, muscle cars, and high-output street builds where a wide, low-profile 17-inch fitment is required.
The P275/40R17 is physically identical to the 275/40R17 (without P) and 275/40ZR17; all three share the same 275 mm width and 25.7-inch diameter.
The "P" in P275/40R17 simply identifies it as a P-metric tire, meaning its load and inflation are calculated using American (TRA) passenger car standards rather than European (Euro-metric) or high-speed (ZR) conventions.
The P-metric version of 275/40R17 is specifically optimized for U.S. passenger vehicles like Corvettes or Mustangs, whereas the versions without the "P" are often built to European or ultra-high-performance specs that handle slightly higher pressures.
Note: The calculated overall diameter of P275/40R17 is ≈25.7 inches. Actual mounted diameter can vary slightly (±0.1–0.3 inches) by tire line and construction.
P275/40R17 is a confirmed factory application of the Chevrolet Corvette C4, specifically the ZR-1 and select performance editions from 1988 to 1996, where it appeared as a front fitment. That makes the C4 the anchor vehicle for this designation and separates it clearly from the muscle car fitments documented under 275/40ZR17.
Beyond the Corvette, P275/40R17 is primarily an aftermarket and street/strip size, used on modified rear-drive performance platforms where a wide, low-profile 17-inch drag-radial fitment is required.
A P275/40R17 tire is approximately 10.7 inches wide, 25.7 inches tall, and carries a sidewall height of roughly 4.33 inches.
P275/40R17 in inches: 25.7″ × 10.9″ R17
The most relevant targets in P275/40R17 size are P275/40R17 drag radials, P275/40R17 street/strip tires, and P275/40R17 ultra-high-performance rear tires for modified muscle cars. Current listings from Nitto, Hoosier, Mickey Thompson, Toyo, and Falken support that positioning.
P275/40R17 tires have 275 mm in section width, use a 40% aspect ratio, and fit 17-inch wheels. The calculated diameter is approximately 25.7 inches (mainstream UHP products spec at 25.63 - 25.67 inches with drag-radial constructions reaching up to 25.8 inches).
The P275/40R17 size appears on performance coupes, muscle cars, and high-output street builds where a wide, low-profile 17-inch fitment is required.
The P275/40R17 is physically identical to the 275/40R17 (without P) and 275/40ZR17; all three share the same 275 mm width and 25.7-inch diameter.
The "P" in P275/40R17 simply identifies it as a P-metric tire, meaning its load and inflation are calculated using American (TRA) passenger car standards rather than European (Euro-metric) or high-speed (ZR) conventions.
The P-metric version of 275/40R17 is specifically optimized for U.S. passenger vehicles like Corvettes or Mustangs, whereas the versions without the "P" are often built to European or ultra-high-performance specs that handle slightly higher pressures.
Note: The calculated overall diameter of P275/40R17 is ≈25.7 inches. Actual mounted diameter can vary slightly (±0.1–0.3 inches) by tire line and construction.
P275/40R17 is a confirmed factory application of the Chevrolet Corvette C4, specifically the ZR-1 and select performance editions from 1988 to 1996, where it appeared as a front fitment. That makes the C4 the anchor vehicle for this designation and separates it clearly from the muscle car fitments documented under 275/40ZR17.
Beyond the Corvette, P275/40R17 is primarily an aftermarket and street/strip size, used on modified rear-drive performance platforms where a wide, low-profile 17-inch drag-radial fitment is required.
A P275/40R17 tire is approximately 10.7 inches wide, 25.7 inches tall, and carries a sidewall height of roughly 4.33 inches.
P275/40R17 in inches: 25.7″ × 10.9″ R17
The most relevant targets in P275/40R17 size are P275/40R17 drag radials, P275/40R17 street/strip tires, and P275/40R17 ultra-high-performance rear tires for modified muscle cars. Current listings from Nitto, Hoosier, Mickey Thompson, Toyo, and Falken support that positioning.
Does P275/40R17 come in normal all-season options?
Is P275/40R17 a drag radial or a street tire?
Is P275/40R17 a passenger tire or a drag tire?
What is the difference between P275/40R17 and P285/40R17?